Straight Line Action Clamps（Type：Side Push）

• 

  Sub-Part Clamp

  HALDER

  The sub-part clamp and the sub-part stop enable workpieces to be clamped on the front face. This allows the full area of the machine table to be used to clamp the workpiece.
  - down-hold effect through an angled jaw face
  - clamping of large workpieces on the whole of the machine table
  - large clamping forces of up to 20 kN
  - solid version made of vibration-eliminating ductile iron
  - optimal adaption to the workpiece and material through the use of clamping inserts and interchangeable jaws
  - force closure is possible with a fixed slot tenon EH 23110. in a T-slot
  - minimum interference of clamping areas - even for large workpieces
  - location holes at the sides for fastening of longitudinal stops if required
  

  CAD ：

  3D

  Days to Ship:	12 Days

• 

  Clamping Vices/moveable jaw

  HALDER

  The clamping vice is a solid, compact clamping module with a horizontally acting clamping force and a robust mechanical spindle.
  - clamping force up to max. 80 kN
  - clamping stroke 25 mm via screw drive WS 36
  - fixture via 4 cap screws M 24, quality 8.8 (tightening torque 600 Nm) with a hole spacing 100 x 100 mm
  - suitable clamping jaws 23231.0020 - .0033 are available
  

  CAD ：

  3D

  Days to Ship:	12 Days

• 

  Standard Jaws, for vices

  HALDER

  •Type: Side Push
  •Nominal Dimension (mm): 100
  •Plunger: Heat-treated steel, induction hardened
  •Conflict Mineral Free: yes
  •Reach Compliant: yes

  CAD ：

  3D

  Days to Ship:	12 Days

• 

  Interchangeable Jaws, for vices, with pull-down effect

  HALDER

  The interchangeable jaws - held by 2 permanent magnets - can be inserted and exchanged with a manual handle.

  CAD ：

  3D

  Days to Ship:	12 Days

Loading...