(!)Due to Microsoft's end of support for Internet Explorer 11 on 15/06/2022, this site does not support the recommended environment.

Cross Hole Deburring Tool, Ceramic Grindstone Model

Cross Hole Deburring Tool, Ceramic Grindstone Model:Related Image
Part Number
CESC-2-PM
CESC-5-PO
CESC-7-PM
Part NumberMinimum order quantityVolume DiscountDays to Ship Grain Size (Gage)
(#)
Grain Size (Color) Head Shape Head size Primary Processing Hole Diameter
(mm)
1 Piece(s)Available

7 Days or more

220GrayCylinderØ 3 * 3Ø 3 mm +
1 Piece(s)Available

7 Days or more

400OrangeSphereφ5More than Ø 5 mm
1 Piece(s)Available

7 Days or more

220GraySphereφ6Over Ø 6 mm

Loading...

  1. 1

Specifications

Cross Hole Deburring Tool, Ceramic Grindstone Model:Related Image
Model Number No. Particle Size (#)
(selection)
Head
Shape
Head Size Target
Primary Processing Hole Diameter
CESC 1 PM (#220 Equivalent): Gray

PO (#400 Equivalent): Orange

PB
(#800 Equivalent): Blue
Sphere φ3 More than φ3 mm
2 Cylinder φ3 x 3
3 Sphere φ4 More than φ4 mm
4 Cylinder φ4 x 4
5 Sphere φ5 More than φ5 mm
6 Cylinder φ5 x 5
7 Sphere φ6 More than φ6 mm

More Information

■ Usage
● Efficient for removing fine burrs produced after machining with a burr base thickness of 0.2 mm or less.
● It is ideal for point machining for cross hole fine burrs.
● Use by mounting it to a hand tool, machining center, NC lathe or robot.


It emphasizes its sharp blade by using a ceramic fiber grindstone on its head.
The shaft part has been made elastic to soften the contact with the work piece.

■ Operating Precautions
● Insert the shank to the chuck deeply and tighten it securely when mounting a rotating tool.
● Carry out a trial run for 1 minute or more before work and for 3 minutes or more when the tool is replaced in order to confirm there is no abnormality such as vibration or looseness on the tool mounting part. Even when there is no problem found in the trial run, immediately stop rotation if an abnormality such as vibration occurs during use. It is dangerous since head breakage or shaft snap, deformation or breakage may occur.
● The maximum rotation speed is: φ6 = 10,000 min-1, φ5 = 12,000 min-1, φ4 = 13,000 min-1 and φ3 = 15,000 min-1. It is dangerous to exceed the maximum operation rotation speed since its head or shaft may break.
● The cutting load to the workpiece should be 5 N or less (500 gf, bending deflection amount of 2 mm). It is dangerous to use the product with an excessive cutting load since its shaft may snap or break.

Cross Hole Deburring Tool, Ceramic Grindstone Model:Related Image

Cross Hole Deburring Tool, Ceramic Grindstone Model:Related Image

Example

Cross Hole Deburring Tool, Ceramic Grindstone Model:Related Image

Basic Information

Product Model Automatic Commodity Contents Grindstone Shank Size(mm) 3*30

Additional Products in this Category

Complementary Products

Tech Support